Posted by Dennis (64.12.103.37) on January 25, 2001 at 05:45:17:
In Reply to: Re: motor help posted by Earl on January 24, 2001 at 23:30:24:
I would do the following, remove valve cover & plugs. Turn the motor over by hand & make sure all valves are operating. Then bring up #1 cyl on TDC. Check where the rotor is pointing. Next run a compression check on all cylinders. If all is ok up to now, then it has to be a electrical problem.
One thing that drove me nuts way back was my dist had a bad ground to the points plate.