Posted by Inshan (38.37.15.139) on March 02, 2001 at 11:47:13:
well, for those of you who remember last month's board... the problem i was having with the engine locking up when i tightened the bell housing bolts turned out to be because of the flexplate.
i have a 5.0HO with the 50oz balance. so i got a FMS C4 50oz flexplate, however the 50oz weight is so big that it hits the trans/block spacer plate. the way i see it, my options are (1) run without the spacer, or (2) use washers behind the flexplate(not sure if this is a good idea)
please advise me accordingly, those that have encountered this sort of thing.
on another note, did 351W's change in the form of pulleys thru the years? Still have to buy a harmonic damper for an engine that is far away from me(can't look at it to tell). did they have 3 and 4 bolt pulleys? or are they all one and the same?
thanks,
inshan